parkdinosaur.com

  • info@parkdinosaur.com
  • 0086 191 4121 5401
  • 0086 191 4121 5401

parkdinosaur.com

How to load the animatronic dinosaur into the container?
2020-05-12 15:20:00

How to load the animatronic dinosaur into the container?


It was a very busy day of May 9, 2020, staffs of PARKDINOSAUR were loading two 40HQ containers to Slovakia. Because all the animatronic dinosaurs were made in real size with 3 to 20 meters in length, they were considerably heavy and cannot be lifted manually during loading, so cranes or forklifts had to be used.

Normally when the length or height of the dinosaur exceeds the size of the container, the dinosaur’s neck, tail, or legs shall be cut in parts to ensure that the dinosaur can be loaded into the container. When the customer receives them, we will send the installation manual and video, or our engineers will go to the site to assist the customers to install.

Because there are many electronic circuits and motors inside the electronic dinosaur, when using a crane, the sling rope can only hold the tail and forelegs of the dinosaur, or the bottom steel frame. It is strictly forbidden to hold any part of the body and be sure to keep the balance of the dinosaur.

After being installed in the container, to avoid damage caused by the dinosaur moving back and forth during transportation, the position of the steel frame at the bottom shall be fixed with triangular wood or rope.

More details about the loading animatronic dinosaur, please contact us freely.

parkdinosaur.com